tech.safesquid.com

Hi.

To integrate OpenLDAP with SafeSquid Active Directory we follow the documentation on this link:

https://docs.safesquid.com/wiki/Integra ... _SafeSquid

However, even after following each of those steps, I am unable to connect to the SafeSquid directory. The directory is blank.

These are the settings I made:

There was a very small mistake. I have listed a few possibilities from which yours could be either one or more.

1. Check your FQDN/IP address. You need to put either one of them and not both.
If you are following the docs, it's not necessary you need to put the same IP (192.168.27.10). Your IP could be different.

2. Check the Username carefully. Mine was supposed to be " cn=admin,dc=renayy,dc=local "

3. Check the Basedn. In my case, it should have been " dc=renayy,dc=local "

4. Check whether you have enabled protected authorization while integrating LDAP, i.e. add username and password when adding server details. Here's a screenshot for reference.

After making changes, this is the whole configuration while adding a new LDAP server to SafeSquid.